Supplies

Filigree Bead Cap (30095459)
Chandelier (30109598) - or chandelier finding
Ball Hook Earring Wire (30095450)
35mm Head Pin (30095460)
2 packages 4mm Black Bicone Crystal (30094997)
6mm Black Bicone Crystal (30095016)
8mm Black Round Crystal (30095035)
8mm Bronze Pearl (30097768)
6mm Bronze Pearl (30097734)

Tools:
round Nose Pliers
Wire Cutters

Directions
 

1. Snip the head off of 8 head pins, keeping your wire cutters flush with the head. This will allow for the maximum of usable wire
2. Using the round nose pliers, form a loop at one end of 6 of the wire
3. Thread an 8mm pearl, 4mm bicone, 6mm pearl and a 4mm bicone onto each of the 6 wires. Form a loop. Attach a pearl/crystal link to each loop of the chandelier bottom
4. For the remaining two wires from step 1, form a wrapped loop at the end of each wire. Before finishing the wrapped loop be sure to attach each wire to the top of each chandelier
5. Thread on a bead cap, 8mm round and another bead cap. Then form a wrapped loop. Attach the earring wire to the top loop. Repeat for the second earring
6. Thread 4 head pins with a 6mm bicone each. Form a wrapped loop; be sure to attach the drops to the outer links as shown in the photograph
7. Thread 2 head pins with an 8mm round each. Form a wrapped loop; be sure to attach the drops to the center links as shown in the photograph