Supplies

1 qty. Round Flat Disk Clear glass ornament #30062538
1 qty. 3” x 5” White Foamie #77613612 for the ears
1 qty. 1” x 2” Black Cardstock for the eyes
1 qty. 1” x 1” Yellow Cardstock for the nose
1 qty. 2” x 3” Red Glitter Foamie #30089279 for the Bow Iridescent Shreds #30017813 or 30017814
¼” Meriken Double stick tape #30013284
Pencil for tracing
Sharp Scissors
Small Oval Punch #30028696
Low temp glue Gun & Glue sticks

Directions
 

Remove the ornament’s cap. Fill the ornament with the iridescent shreds. Put the ornament cap back on.
Trace and cut out pieces from foamie and cardstock as indicated on the patterns. Use the oval punch and punch out two ovals from the black cardstock and one from the yellow cardstock.
Follow the pictured sample for placement and place the black ovals on the glass ornament for the eyes and the yellow oval for the nose. Tape in place.
At the center of the straight edge of the ear, snip about 3/8” in. Overlap at the snip and secure with a little glue. Shape the foam ears along the top sides of the ornament and glue in place. Position the bow cut-out near the left ear and tape in place.