Supplies
 

1 qty. 3” x 8” Foamie-Mint 30041091

1 qty. 3.5” x 4” Foamie-Lavendar 30041088 (frame)

1 qty. 3.5” x 4” Foamie-Pink 77613596 (frame backing)

10” of ¼” satin ribbon (color of choice)

Tools

Scissors

Pencil

Ruler

Low temp. glue gun & glue sticks

Pattern

Directions

Trace and cut out pieces from Foamies according to the pattern.

Cut 2 pieces of ribbon measuring 1 ½”each. Glue one of the 1 ½” ribbons down about a ½” from the bottom center of one of the letter “m”. Glue the other end of the same ribbon down about a ½” from the top center of the pink flower (frame backing). There should be 1” of ribbon between the “m” and pink flower. Take the other 1 ½” ribbon and glue it down about a ½” from the bottom of the pink flower. Glue the other end of the same ribbon down about a ½” from the top center of another letter “m”. There should be 1” of ribbon between the pink flower and the second letter “m”.

Take the remaining 7” or ribbon, fold it in half and glue the ends together. Glue the ends of the ribbon down about a ½” from the top of the “m” above the flower. This will be the hanger. Glue another “m” down onto the same “m” so that the ribbons are “sandwiched” between 2 “m’s”. Repeat for the other “m” below the pink flower.

Take the lavender flower (frame) and glue it on top of the pink flower, but only glue the bottom half of the flower down around the edges. This will leave an opening to slip a photo into the top half of the frame.