Nature's Beauty Winter Card
This project courtesy of Fiskars®.
|
Supplies FISKARS® Texture Plates Expression FISKARS® 12"/30cm Euro Personal Paper Trimmer FISKARS® ShapeBoss™ Embossing System Starter Set FISKARS® ShapeBoss™ Stencil Set Winter Wonderland Dark green and light brown chalk by Craft-T products White Cardstock - 5½” x 8½”, 2¾” x 1” and 4¼” square Green Cardstock – 4” square Black marker Adhesive Wax paper optional |
|
|
Directions Fold the 5½” x 8½” piece of white cardstock in half to form a card. Rub the inside front of the card with wax paper. Position the front of the card front face down on the Snowflake Texture Plate and tape in place. Using the Texturing Tool, texture the inside front of the card. Tip: Scribble with the texture tool one way then switch and go the other way. This allows for a more detailed impression. Remove the tape and set the card aside. Place the Winter Wonderland stencil onto one side of the ScrapBoss and use pegs to hold in place. Position the 4 1/4” square of white cardstock so that it is centered beneath the pinecone design. Emboss pinecone design then turn the stencil over and chalk the design with light brown and dark green as shown in the card example. Carefully tear the edges of the cardstock on all sides center and adhere to the 4” square of green cardstock. Center and adhere the embossed design to the top of the card as shown in the card example. Ink the stamp with the Pine green ink pad then stamp onto the 1” x 2¾” strip of white cardstock. Edge the cardstock strip with the ink pad.
Adhere the stamped cardstock to the bottom of the page as shown in the
page example.
|
|
