Puppy Photo Frame
SUPPLIES:
Note
– frame is for a 3.5” x 5” photo
4.5” x 6” Fun Foam, Color 1
4” x 5.5” Fun Foam, Contrasting Color 2
2” x 2.5” White Fun Foam
1.5” x 1.5” Black Fun Foam
2 – 10mm Moving Eyes
5mm Black Pom Pom
4” Magnet Strip
4” of ¼” ribbon for bow
Low
temp glue gun & glue sticks
DIRECTIONS:
Trace
and cut out pieces from fun foam according to the patterns. Make
sure you cut out the center of the frame top piece.
Center
the frame top piece onto the backing piece, there should be a
¼” border all around. Glue the bottom and 2 sides of the top
piece to the backing, leaving the top edge open. Run the glue
close to the edge, so that it will be easy to slide a photo in.
Assemble
the puppy’s head. Glue the eye black patch to the head. Glue one
moving eye on top of the patch. Glue the white layering piece next
to the patch. Glue the other moving eye on top of this piece. This
will keep the eyes level. Glue the black pom pom below the eyes
for the nose.
Glue
the puppy’s head to one of the bottom corner’s of the frame.
Place and glue the paws below the head on either side. Make a bow
with the ¼” ribbon. Glue the bow below the puppy’s chin.
Attach the magnet strip to the upper back of the frame. Slip in your photo.
