Supplies

7 ½” x 8 ½” Red Foamie #7761 3760 for hat

2 pcs. of 7 ½” x 12” Red Foamie #7761 3760 for arms

1 ½” x 1 ½” Red Foamie #7761 3760 for nose

7” x 8” Flesh Foamie #7761 3463 for face

3” x 5” Pink Foamie for cheeks #7761 3596

9” x 10” White Foamie #7761 3745 for beard

2 ½” x 6 ½” white Foamie #7761 3745 for mustache

2 pcs. of 3 ½” x 9 ½” White Foamie #7761 3745 for cuffs

2 ½” x 8” White Foamie #7761 3745 for hat trim

2 pcs. of 5” x 5 ½” Black Foamie #7761 3620 for gloves

2 – 25mm Moving Eyes #7767 6247

3/8” Wood Dowel – 36” length #7771 8338

10 yd.  roll of ¼” Red Satin Ribbon #7780 1357

3 – 38” lengths of 1 ½” – 2” ribbon for card streamers (red/white to match)

20mm Jingle bell #7766 2643

Tacky Glue #7760 9875

Crystal Glitter #7756 5952

Low Temp Glue Gun and Glue sticks

Paper Clips

Optional: Shiny White Scribbles paint #7752 7861

Directions

Trace and cut out pieces from foamies according to the patterns.

Patterns

Face

Cheek

Nose

Mustache

Santa Beard

Glove

Sleeve Cuff

Santa Hat

Hat Trim

Take the white beard piece. Using either Shiny White Scribbles paint or tacky glue, draw

out swirly circles allover the beard. Sprinkle with crystal glitter and shake off excess glitter.

Set aside to dry. Take the white mustache piece and draw  outline swirls, matching the

design on both sides. Sprinkle with glitter and let dry. Take the white hat trim piece and

draw swirly balls. Sprinkle with glitter and let dry.

Place the eyes and pink cheeks on the face. Place the beard around the face. Place the

mustache so that it touches top of the beard and place the red nose on the top center

of the mustache. Glue all in place.

Place the hat on top of the head at a slight angle. Place the hat trim along the bottom of

the hat just above the eyes. Glue all in place. Fold down the top of the hat to one side and

glue in place. Glue the jingle bell to the tip of the hat.

Lay the wood dowel in front of you. Cut a 48” piece of the red ¼” ribbon. Tie the ends of

the ribbon to wither side of the dowel to make the hanger. Knot securely. Take the three

38” lengths of 1 ½” ribbons to glue onto the dowel. Place one of the ribbons on the center

of the dowel. Fold about 2” of one ribbon edge over the dowel and glue to the dowel. Repeat

with the other two ribbons but placing them about 6” in from the ends of the dowel. Trim

each bottom edge of the ribbons into an inverted “V” to finish. This is where you will attach

your cards for display.