Stars
Scrapbook Page
This project is
courtesy of Fiskars®.
|
Supplies Fiskars® ShapeBoss™ Embossing System Starter Set Fiskars® Embossing Stencil Set - Basic Fiskars® Embossing Stencil Set - Alpha Block Letters Fiskars® ShapeCutter™ Tool Fiskars® ShapeTemplate™ Tool - Tags-1 with Seagull Border Fiskars®
Self-Healing Craft Mat 12˝" x 12˝" Fiskars® Hand Punch - 1/8" Circle Cardstocks - 12" x 12" periwinkle, 8˝" x 11" sheet of white, butter yellow Twistel - yellow Yellow embroidery thread Eyelets - (10) blue, (2) white, (2) yellow Eyelet applicator tool Hammer Double-sided foam tape Decorating Chalk - blue Black & White photo Sticky foam pop dots Black pen |
|
|
Directions Using photo stickers, mount photo to white cardstock. Trim white cardstock around photo leaving a 1/16" border. Cut a piece of yellow cardstock to measure 7" x 9". Also cut a piece of white cardstock to measure 8˝" x 4˝". Adhere white piece to upper right corner of periwinkle paper, and yellow piece to lower left corner of periwinkle paper. Cut five pieces of white cardstock to measure 2" x 2". Insert one square between Alpha Block Stencils on ShapeBoss™ tray. On each letter, emboss one letter in the word "WAGON". Using hand punch, punch a hole in the center of both top and bottom edges of each square. Insert eyelet into squares. Flip over onto craft mat. Insert eyelet tool into backside of eyelet. Gently tap 2 - 3 times onto tool, or until backside of eyelet begins to curl over. Remove tool, then tap directly onto eyelet to finish. Repeat for all eyelets. Cut a piece of Twistel to measure approximately 20". Tie a knot in one end. Begin threading other end through pieces, making sure the longest portion is behind letter blocks. After this has been threaded through each letter, tie knot in other end and trim both ends. Apply pop dots to backside of each letter. Replace alphabet stencil with Basic Shapes stencil, then emboss varying sizes of yellow and blue stars. Trim around embossed shapes with scissors. Apply pop dots to just a few of the stars. Using ShapeCutter™ with Tags ShapeTemplate™ and craft mat, cut 2
round tag shapes from white cardstock. Punch hole in tag at curved
end. Apply yellow eyelet to each hole according to directions above.
Using black writing pen, journal child's name on one tag, and date
of photo on other tag. |
|
