|
Directions
Sand rough areas on box, if necessary. Brush dust away from surface.
Paint entire surface of box (inside and out) with gold paint. Allow to
dry.
Brush a medium coat of crackle medium onto outer surfaces of box
(front, back, sides and bottom). Allow to dry.
Apply coat of green paint to same surfaces crackle finish was applied
to. Set aside to dry. After box is dry, sand all outer surfaces for a
"worn" look.
Cut a piece of tan cardstock to measure 3"
x 3". Trim edges using
Stamp Paper Edgers. Run gold paint marker along stamp edges to create gold
border.
Using ShapeCutter with Flowers ShapeTemplate and craft mat, cut one
large circle from white cardstock.
Cut 5 small leaf shapes from maroon cardstock. Adhere leaf shapes to
white circle, making sure all points meet in center of circle. Flip circle
over so leaf shapes are on side facing away from you, and trim maroon
cardstock edges away along edge of white circle.
Cut a piece of Saran Wrap to measure approximately 5"
x 5". Lay
circle, swirl side down, in center of cardstock piece. Fold two edges over
to meet in the center behind circle. Secure to circle using photo
stickers. Twist two unsecured edges, resembling a piece of candy. Adhere
at a diagonal to tan cardstock piece using craft bond glue. Adhere
cardstock piece to center of front side of box.
Lay box down so candy piece is facing up. Using a pencil, lightly
outline the word "SWEETS" along the curve of the handle. Once you are
satisfied with placement of the letters, trace over pencil marks using
gold paint marker. Leave box laying in this position until all pieces are
completely dry.
printer-friendly
version
Back Home
Search Category
Search Name |