Ted E. Bear
|
Supplies 7”
x 9” Brown Felt 3”
x2” Beige/Cream Felt 2
– 10mm Moving Eyes ¼”
Black Pom Pom ½”
Brown Pom Pom 4”
of ¼” satin ribbon for bow Low
Temp glue gun and glue sticks |
|
|
Directions Trace
and cut out pieces from felt according to the
patterns. As indicated,
cut out hole on one of the body pieces. This will be the body Front. Place
the paw pieces on the body Front, coming outward from the sides a little
below the hole opening. Tack in place to the back of the body Front
using a little glue. Place the body Back to the body Front and align
edges. Glue the sides together, stopping about ½” from the bottom. Open
the body up, and place the bottom wedge piece in between the front and
back, aligning the edges. Carefully glue the bottom wedge piece to the
bottom edges of the body. Start by gluing one edge at a time. Position
the feet below the body and glue in place. Glue the ½” brown pom pom
to the back of the body for a tail. Set aside. Glue
the muzzle to the lower center of the bear’s face. Glue the eyes above
the muzzle. Glue the nose below the eyes. Center and glue the tummy
below the bear’s face, about ½” down. Make a bow with the ¼”
ribbon and glue below the bear’s chin. Position
the bear’s head onto the body. Make sure the bear’s tummy covers the
opening. Glue head in place. To
fill your bear with treats, lift the tummy flap and place treats in
through the opening. |
|
